Just last week I did the first part of the review of the Anycubic Photon S. One of the pain points of printing was the long workflow. Chitubox Prusa slicer Photon File Validator Photon Workshop First thing I have to decide is if the model needs to be hollowed to conserve resin. I load up the model in Chitubox and use the built-in tool to hollow the model. After the models hollowed and a drain hole is placed I export it to an STL and open with Prusa Slicer. In Prusa Slicer, I orient the model and use its auto-support feature and auto-orient feature. It is a roll of the dice if the orientation makes sense. I want all the supports to be on the back/bottom of the print. Little marks are left when removing the supports. I have found that Prusa Slicer has the best auto support feature. Then [...]
The post Quick Update for the AnyCubic Photon S Photon Workshop V2.1.17.RC1 appeared first on CNX Software - Embedded Systems News.